# ScriptInactivityTimeout

The length of time for which the scripts on a page must be inactive, for the connector to determine that the scripts are finished and the page can be processed.

Some web pages contain scripts that never finish. For example, a page might contain a script that performs an AJAX request and then schedules itself to run again five seconds later. During the five-second interval between the script completing and running again, the script is inactive.

NOTE: Micro Focus recommends using a short time duration, because the connector must wait for at least the specified amount of time for every page that contains scripts. Increasing the duration of `ScriptInactivityTimeout` could significantly increase the time required to complete a synchronize cycle.

Type: | Time duration The value of this parameter is a time duration. Specify a value using one or more of the following units:
         years      y
         months     m
         weeks      w
         days       d
         hours      h
         minutes    n
         seconds    s
Note that months abbreviates to m, minutes to n. If you want to specify the value in seconds, units are not required. For example, all of the following are equivalent:
         1minute 3seconds
         1n 3s
         63s
         63
Default: | 0.5s
Required: | No
Configuration Section: | TaskName or FetchTasks
Example: | `ScriptInactivityTimeout=0.2s`
See Also: | MaxWaitForScripts

_FT_HTML5_bannerTitle.htm